How to properly inject Trenbolone Acetate or other steroids
Once you have advanced to the level where you are no longer only cycling with oral steroids, self-administering your steroids can be nerve wracking. There are some that won’t even consider injectables because the thought of sticking themselves is just too much to handle. We suggest asking a friend, gym buddy or significant other/spouse to assist you or even do the injections for you until you become comfortable with hitting yourself. It takes time and patience but if you follow the steps we’ve provided, you’ll be a pro in no time!
How to properly inject steroids
Any injections must begin with the preliminary preparation of the syringe and steroid. Trenbolone Acetate and Testosterone esters are oil-based solutions, which are designed to better absorb within the body and facilitate the introduction process. Before injecting the steroid, some suggest to warm up the steroid by rubbing the bottle or vial in between the palms of both hands. To get the steroid into the syringe, you must take off the cap of the syringe. Many experienced athletes pick up oil without a needle, which is much faster and more efficient.
Before the injecting Trenbolone Acetate or any other steroid, it is recommended to clean the area with an alcohol absorbed cotton swab. Once you have the steroid solution in the syringe be sure to get out any air bubbles by pushing up on the plunger until there are no visible air bubbles. Inject the steroid in slowly and continuously without any sudden jerks, pausing or sudden movements. After the injection, some suggest using an alcohol-soaked cotton swab to clean the area where the steroids were injected. This may promote faster healing of the site.
Trenbolone Enanthate is the longer ester version of Trenbolone that has a slow absorption rate and a half-life of ten to twelve days.
Trenbolone Acetate has a half-life of three days and therefore needs to be injected every other day at the very least to get the desired effects and experience its great results. For those interested in entering bodybuilding competitions, powerlifting competitions or for athletes who compete in drug-tested contests, the detection time for Tren Ace is four to five months.
How Much to inject (dosages, weekly plan)
- Trenbolone Enanthate – 200mg twice a week (400mg a week)
- Trenbolone Acetate -100mg every other day (400mg a week)
Instruments for the administration of Trenbolone Acetate
The syringes for anabolic steroids injections are based on personal preference. Most commonly, a 3cc, 21-gauge, 1-inch syringe is used for injections. Others will use 23 or 24-gauge, 1 ½ inche syringes. It is important to note the basic items needed for injections:
- Syringe for 2-5 ml;
- Cotton swab(s);
- Concentrated alcohol;
- Peroxide (if necessary);
- Glass ampoule opener (optional).
The syringes are available at your local pharmacy and do not require a prescription. It is recommended to choose syringes up to 5 ml, however, it is not required. Thinner needles may allow the individual to inject the steroid with minimal pain. At times, pain will be associated with frequent injections so it’s best to always rotate the injection site. The glutes, upper thigh area and shoulder are considered the best areas to inject. Always make sure the muscles are relaxed as injections made into flexed muscles will make it harder for the solution to go through the skin. Rub the injection site with your fingers for a few minutes following the injection to alleviate any build-up and allow the solution to go deeply into the tissue. Many athletes and bodybuilders have antibiotics on hand in the rare cause of infection to the site.